Ads
related to: how to engrave a plate with metal
Search results
Results From The WOW.Com Content Network
Engraving is done with a burin, which is a small bar of hardened steel with a sharp point. It is pushed along the plate to produce thin furrowed lines, leaving "burr" or strips of waste metal to the side. This is followed by the use of a scraper to remove any burs, since they would be an impediment during the subsequent inking process.
Other terms often used for printed engravings are copper engraving, copper-plate engraving or line engraving. Steel engraving is the same technique, on steel or steel-faced plates, and was mostly used for banknotes, illustrations for books, magazines and reproductive prints, letterheads and similar uses from about 1790 to the early 20th century, when the technique became less popular, except ...
Metal plates could be stored and reused, which made this method an attractive option for music engravers. Copper was the initial metal of choice for early plates, but by the eighteenth century pewter became the standard material due to its malleability and lower cost. [2] At first, plates were engraved freely by hand. Eventually, music ...
When the surface of a metal plate is sufficiently polished to be used for engraving, the slightest scratch upon it will print as a black line. An engraved plate from which visiting cards are printed is a good example of some elementary principles of engraving. It contains thin lines and thick ones, as well as a considerable variety of curves.
The plate's ground side is then dipped into acid, or the acid poured onto it. The acid bites into the surface of the plate where it was exposed. Biting is a printmaking term to describe the acid's etching, or incising, of the image; its duration depends on the acid strength, metal's reactivity, temperature, air pressure and the depth desired. [8]
Diagram of rotogravure process. Rotogravure (or gravure for short) is a type of intaglio printing process, which involves engraving the image onto an image carrier. In gravure printing, the image is engraved onto a cylinder because, like offset printing and flexography, it uses a rotary printing press.