Search results
Results From The WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The hope was that by forcing annual emissions testing for California starting in 1988, [18] and denying registration to vehicles that did not pass, drivers would tend to purchase vehicles that would more reliably pass the test. OBD-I was largely unsuccessful, as the means of reporting emissions-specific diagnostic information was not standardized.
The NTE test, as defined in CFR 86.1370-2007, establishes an area (NTE control area) under the torque curve of an engine where emissions must not exceed a specified emission cap for a given pollutant. The NTE cap is set at 1.25 times the FTP emission limit as described in the subsection above.
The Monte Carlo needs a new pump to pass the emissions standards, but after contacting several auto parts stores and a Chevrolet dealership, Kersting was told that the part is no longer manufactured.
The EPA Federal Test Procedure, commonly known as FTP-75 for the city driving cycle, are a series of tests defined by the US Environmental Protection Agency (EPA) to measure tailpipe emissions and fuel economy of passenger cars (excluding light trucks and heavy-duty vehicles).
ISO 8178 is a collection of steady state test cycles used for defining emission standards for non-road engines in the European Union, United States, Japan and other countries. Test cycle ISO 8178 C1 is also referred to as "Non-Road Steady Cycle" and used extensively.
The Worldwide Harmonised Light vehicles Test Procedure (WLTP) [1] is a global driving cycle standard for determining the levels of pollutants, CO 2 emission standards and fuel consumption of conventional internal combustion engine (ICE) and hybrid automobiles, as well as the all-electric range of plug-in electric vehicles.
Depiction of the no fault found cycle. Each clockwise cycle after the initial is a waste of maintenance resource. As the figure shows once a fault has been reported, investigated, and no fault found any future problems caused by the fault cause additional work which is a waste of maintainer time. Different causes have been suggested for this issue.