Search results
Results From The WOW.Com Content Network
The "international volt" was defined in 1893 as 1 ⁄ 1.434 of the emf of a Clark cell. This definition was abandoned in 1908 in favor of a definition based on the international ohm and international ampere until the entire set of "reproducible units" was abandoned in 1948. [15]
Voltage, also known as (electrical) potential difference, electric pressure, or electric tension is the difference in electric potential between two points. [1] [2] In a static electric field, it corresponds to the work needed per unit of charge to move a positive test charge from the first point to the second point.
An electronvolt is the amount of energy gained or lost by a single electron when it moves through an electric potential difference of one volt. Hence, it has a value of one volt, which is 1 J/C, multiplied by the elementary charge e = 1.602 176 634 × 10 −19 C. [2] Therefore, one electronvolt is equal to 1.602 176 634 × 10 −19 J. [1]
where E is the electric field vector with units of volts per meter (analogous to V of Ohm's law which has units of volts), J is the current density vector with units of amperes per unit area (analogous to I of Ohm's law which has units of amperes), and ρ "rho" is the resistivity with units of ohm·meters (analogous to R of Ohm's law which has ...
It is usually measured in volts, and one volt is the potential for which one joule of work must be expended to bring a charge of one coulomb from infinity. [ 25 ] : 494–98 This definition of potential, while formal, has little practical application, and a more useful concept is that of electric potential difference , and is the energy ...
The definition of extra-high voltage (EHV) again depends on context. In electric power transmission engineering, EHV is classified as voltages in the range of 345,000– 765,000 V. [ 6 ] In electronics systems, a power supply that provides greater than 275,000 volts is called an EHV Power Supply , and is often used in experiments in physics.
Where two voltages are given below separated by "/", the first is the root-mean-square voltage between a phase and the neutral connector, whereas the second is the corresponding root-mean-square voltage between two phases (exception: the category shown below called "One Phase", where 240 V is the root-mean-square voltage between the two legs of a split phase).
The volt-ampere (SI symbol: VA, [1] sometimes V⋅A or V A) is the unit of measurement for apparent power in an electrical circuit. It is the product of the root mean square voltage (in volts) and the root mean square current (in amperes). [2] Volt-amperes are usually used for analyzing alternating current (AC) circuits.