Ad
related to: data transfer rates explained
Search results
Results From The WOW.Com Content Network
In telecommunications, data transfer rate is the average number of bits , characters or symbols , or data blocks per unit time passing through a communication link in a data-transmission system. Common data rate units are multiples of bits per second (bit/s) and bytes per second (B/s). For example, the data rates of modern residential high ...
A USB device pulls one of the data lines high with a 1.5 kΩ resistor. This overpowers one of the 15 kΩ pull-down resistors in the host and leaves the data lines in an idle state called J. For USB 1.x, the choice of data line indicates what signal rates the device is capable of: full-bandwidth devices pull D+ high,
For example, in the case of file transfer, the goodput corresponds to the achieved file transfer rate. The file transfer rate in bit/s can be calculated as the file size (in bytes) divided by the file transfer time (in seconds) and multiplied by eight. As an example, the goodput or data transfer rate of a V.92 voiceband modem is affected by the ...
Symbol rate or baud rate, the number of symbol changes, waveform changes, or signaling events across the transmission medium per unit of time; Data-rate units, measures of the bit rate or baud rate of a link; Data transfer rate (disk drive), a data rate specific to disk drive operations
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
The system throughput or aggregate throughput is the sum of the data rates that are delivered over all channels in a network. [1] Throughput represents digital bandwidth consumption. The throughput of a communication system may be affected by various factors, including the limitations of the underlying physical medium, available processing ...
The measurable data transfer rate will be the lower (slower) of the two rates. The sustained data transfer rate or sustained throughput of a drive will be the lower of the sustained internal and sustained external rates. The sustained rate is less than or equal to the maximum or burst rate because it does not have the benefit of any cache or ...
If there is a single transfer per clock cycle it is known as Single Data Rate (SDR), and if there are two transfers per clock cycle it is known as Double Data Rate (DDR) although the use of signalling other than SDR is uncommon outside of RAM. An example of this is PCIe which uses SDR. [6] Within each data transfer there can be multiple bits of ...