Ad
related to: what does 10.0.0.0 16 mean on router 6 to wireless modem 7
Search results
Results From The WOW.Com Content Network
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
10.0.0.0/8: 10.0.0.0 – 10.255.255.255: 16 777 216: ... same local physical or wireless network claim to have the same IP address. ... to the router have private IP ...
ffx0::/16, ffxf::/16: Reserved ffx1::/16: Interface-local Packets with this destination address may not be sent over any network link, but must remain within the current node; this is the multicast equivalent of the unicast loopback address. ffx2::/16: 224.0.0.0/24: Link-local Packets with this destination address may not be routed anywhere ...
In computer networking, the default route is a configuration of the Internet Protocol (IP) that establishes a forwarding rule for packets when no specific address of a next-hop host is available from the routing table or other routing mechanisms.
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
IPv6 addresses are assigned to organizations in much larger blocks as compared to IPv4 address assignments—the recommended allocation is a / 48 block which contains 2 80 addresses, being 2 48 or about 2.8 × 10 14 times larger than the entire IPv4 address space of 2 32 addresses and about 7.2 × 10 16 times larger than the / 8 blocks of IPv4 ...
Once a unique link-local address is established, the IPv6 host determines whether the LAN is connected on this link to any router interface that supports IPv6. It does so by sending out an ICMPv6 router solicitation message to the all-routers [44] multicast group with its link-local address as source. If there is no answer after a predetermined ...
R1(config)# ip route 10.0.0.0 255.0.0.0 backupLink 1 254 In the event that two routing protocols are configured with the same administrative distance, the Cisco router will ignore the configured values and instead use the default values.