Search results
Results From The WOW.Com Content Network
There are many changes over the previous 5.9 L ISB for the Dodge truck, the most obvious being the larger displacement. The 6.7 ISB had an increase of cylinder bore and piston stroke to 107 mm × 124 mm (4.21 in × 4.88 in), respectively, thereby giving a displacement of 6.7 L; 408.2 cu in (6,690 cc). [11] [full citation needed]
The 238.2 cu in (3.9 L) V6 was introduced with the Dodge Dakota for 1987, and replaced the older, longer Slant-Six in the Dodge Ram trucks and vans for 1988. It is essentially a six-cylinder version of the 318 V8. The bore and stroke are 99.3 mm (3.9 in) and 84 mm (3.3 in), respectively.
The 400 cu in (6.6 L) B engine was introduced in 1972 to replace the venerable 383, and were power-rated via the net (installed) method. Chrysler increased the bore size of the 383 to create the 400. Its bore of 4.342-inch (110.3 mm) was the largest used in any production Chrysler V8 at the date of its introduction.
1978–1979: 6DR5 2.5 L 6G73 - Used in the Chrysler Sebring, Dodge Avenger, Chrysler Cirrus, and Dodge Stratus; 3.0 L 6G72 - Used in the Plymouth Acclaim/Dodge Spirit and 1987–2000 Dodge Caravan/Plymouth Voyager, also Dodge Dynasty, Chrysler LeBaron, Chrysler TC, Chrysler New Yorker, Dodge Daytona, Dodge Stealth, Chrysler Sebring (Coupe), Dodge Stratus (Coupe), Dodge Shadow ES, and Plymouth ...
It was conceived and prototyped as a Magnum 5.9 with two extra cylinders and a longer stroke of 3.88 in (98.6 mm). The first-generation Viper V10 engine had a displacement of 7,990 cc (8.0 L; 487.6 cu in) and produced 400 hp (406 PS; 298 kW) at 4600 rpm and 465 lb⋅ft (630 N⋅m) of torque at 3600 rpm.
For 1956, Dodge increased the displacement to 315 cu in (5.2 L) with a longer 3.80 in (96.5 mm) stroke and a taller raised-deck block, but used polyspheric rather than hemi heads on the base version. The optional high-performance D-500 version had a four-barrel carburetor and a larger-valved Dodge hemispherical combustion chambered head.
Engine displacement was a factor of the bore: the 250 cu in (4.1 L) has a 3 + 1 ⁄ 2-inch (88.9 mm) bore, 287 cu in (4.7 L) 3 + 3 ⁄ 4 inches (95.3 mm), and the 327 cu in (5.4 L) a 4-inch (101.6 mm) bore. A number indicating the bore size is cast on the top of the engine block's flywheel housing immediately behind the right bank cylinder head.
The Cummins M-series engine is a straight-six diesel engine designed and produced by Cummins.It displaces 10.8 litres (659.1 cu in).Introduced as the M11 in 1994, it was built on the previous L10 engine (same 4.921 inches (125.0 mm) cylinder bore, but a longer 5.787 inches (147.0 mm) piston stroke compared to the L10's 5.354 inches (136.0 mm) stroke).