Search results
Results From The WOW.Com Content Network
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
Data in the header is used by networking hardware to direct the packet to its destination, where the payload is extracted and used by an operating system, application software, or higher layer protocols. Packet switching is the primary basis for data communications in computer networks worldwide.
AS-i – Actuator-sensor interface, a low level 2-wire bus establishing power and communications to basic digital and analog devices; BSAP – Bristol Standard Asynchronous Protocol, developed by Bristol Babcock Inc. CC-Link Industrial Networks – Supported by the CLPA
A datagram is a basic transfer unit associated with a packet-switched network. Datagrams are typically structured in header and payload sections. Datagrams provide a connectionless communication service across a packet-switched network. The delivery, arrival time, and order of arrival of datagrams need not be guaranteed by the network.
The presentation layer handles protocol conversion, data encryption, data decryption, data compression, data decompression, incompatibility of data representation between operating systems, and graphic commands. The presentation layer transforms data into the form that the application layer accepts, to be sent across a network.
A data packet consists of the PID followed by 0–1,024 bytes of data payload (up to 1,024 bytes for high-speed devices, up to 64 bytes for full-speed devices, and at most eight bytes for low-speed devices), [12] and a 16-bit CRC. There are two basic forms of data packet, DATA0 and DATA1. A data packet must always be preceded by an address ...
In digital radio, packet radio is the application of packet switching techniques to digital radio communications. Packet radio uses a packet switching protocol as opposed to circuit switching or message switching protocols to transmit digital data via a radio communication link. Packet radio is frequently used by amateur radio operators.
Broadband over power lines (BPL) is a method of power-line communication (PLC) that allows relatively high-speed digital data transmission over public electric power distribution wiring. BPL uses higher frequencies, a wider frequency range, and different technologies compared to other forms of power-line communications to provide high-rate ...