Ads
related to: aluminum extrusion stock shapes chart
Search results
Results From The WOW.Com Content Network
Bar stock, also (colloquially) known as blank, slug or billet, [1] is a common form of raw purified metal, used by industry to manufacture metal parts and products. Bar stock is available in a variety of extrusion shapes and lengths. The most common shapes are round (circular cross-section), rectangular, square and hexagonal.
Examples of T-slotted profiles 1964 patent demonstrating early use of extruded T-slot members. Cross-section of 80/20 T-slotted profiles, 10 and 15 series A bicycle trailer for bike-trekking with three Euroboxes and aluminium profile framing
6061 is an alloy used in the production of extrusions—long constant–cross-section structural shapes produced by pushing metal through a shaped die. Cold and Hot Stamping. 6061 sheet in the T4 condition can be formed with limited ductility in the cold state.
Most hot extrusions are done on horizontal hydraulic presses that range from 230 to 11,000 metric tons (250 to 12,130 short tons). Pressures range from 30 to 700 MPa (4,400 to 101,500 psi), therefore lubrication is required, which can be oil or graphite for lower temperature extrusions, or glass powder for higher temperature extrusions.
Extrusions are particularly important in this regard, owing to the ease with which aluminium alloys, particularly the Al-Mg-Si series, can be extruded to form complex profiles. In general, stiffer and lighter designs can be achieved with aluminium alloy than is feasible with steels.
Final products include bar stock and wire. [3] Centrifugal casting is also used to produce short circular tubes as billets, usually to achieve a precise metallurgical structure. They are commonly used as cylinder sleeves where the inner and outer diameters are ground and machined to length. Because their size is not modified significantly, they ...
Ads
related to: aluminum extrusion stock shapes chart