Search results
Results From The WOW.Com Content Network
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
Underclocking can also be performed on graphics card processor's GPUs, usually with the aim of reducing heat output. For instance, it is possible to set a GPU to run at lower clock rates when performing everyday tasks (e.g. internet browsing and word processing), thus allowing the card to operate at lower temperature and thus lower, quieter fan speeds.
One GPU performs an antialiasing pattern which is slightly offset to the usual pattern (for example, slightly up and to the right), and the second GPU uses a pattern offset by an equal amount in the opposite direction (down and to the left). Compositing both the results gives higher image quality than is normally possible.
The main AMD GPU software stacks are fully supported on Linux: GPUOpen for graphics, and ROCm for compute. GPUOpen is most often merely a supplement, for software utilities, to the free Mesa software stack that is widely distributed and available by default on most Linux distributions .
The dynamic power (switching power) dissipated by a chip is C·V 2 ·A·f, where C is the capacitance being switched per clock cycle, V is voltage, A is the Activity Factor [1] indicating the average number of switching events per clock cycle by the transistors in the chip (as a unitless quantity) and f is the clock frequency.
General-purpose computing on graphics processing units (GPGPU, or less often GPGP) is the use of a graphics processing unit (GPU), which typically handles computation only for computer graphics, to perform computation in applications traditionally handled by the central processing unit (CPU).
This number is generally used as a maximum throughput number for the GPU and generally, a higher fill rate corresponds to a more powerful (and faster) GPU. Memory subsection. Bandwidth – Maximum theoretical bandwidth for the processor at factory clock with factory bus width. GHz = 10 9 Hz. Bus type – Type of memory bus or buses used.
Die shot of the Polaris 11 GPU used in Radeon RX 460 graphics cards Die shot of the Polaris 10 GPU used in Radeon RX 470 graphics cards. GPUs of the Arctic Islands-family were introduced in Q2 of 2016 with the AMD Radeon 400 series. The 3D-engine (i.e. GCA (Graphics and Compute array) or GFX) is identical to that found in the Tonga-chips. [38]