Ad
related to: fractions to metric conversion
Search results
Results From The WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
Metric signs and metric measurements were removed for the 2009 edition and replaced with an appendix of metric conversion tables. This is in marked contrast to the position in the (largely metric) United Kingdom , where metric road signs are prohibited by law (except for those denoting widths and height restrictions, which include both metric ...
Metric, but some non-metric units are used for specific areas: rural land – alqueire; cattle weight – arroba; screen sizes – polegada (inch); tyre pressure – libra-força por polegada quadrada, but referred by its English abbreviation: psi. Peru: Peruvian (variants of Spanish) Metric, but inches (pulgadas) are used for screen sizes and ...
In the SI system and generally in older metric systems, multiples and fractions of a unit can be described via a prefix on a unit name that implies a decimal (base-10), multiplicative factor. The only exceptions are for the SI-accepted units of time (minute and hour) and angle (degree, arcminute, arcsecond) which, based on ancient convention ...
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.