Ad
related to: thermal energy transfer quick check
Search results
Results From The WOW.Com Content Network
Heat transfer is a discipline of thermal engineering that concerns the generation, use, conversion, and exchange of thermal energy between physical systems. Heat transfer is classified into various mechanisms, such as thermal conduction , thermal convection , thermal radiation , and transfer of energy by phase changes .
Internal energy: The energy contained within a body of matter or radiation, excluding the potential energy of the whole system, and excluding the kinetic energy of the system moving as a whole. Heat : Energy in transfer between a system and its surroundings by mechanisms other than thermodynamic work and transfer of matter.
The macroscopic energy equation for infinitesimal volume used in heat transfer analysis is [6] = +, ˙, where q is heat flux vector, −ρc p (∂T/∂t) is temporal change of internal energy (ρ is density, c p is specific heat capacity at constant pressure, T is temperature and t is time), and ˙ is the energy conversion to and from thermal ...
Values of thermal conductivities for various materials are listed in the list of thermal conductivities. As mentioned earlier in the article the convection heat transfer coefficient for each stream depends on the type of fluid, flow properties and temperature properties. Some typical heat transfer coefficients include: Air - h = 10 to 100 W/(m 2 K)
Adiabatic : No energy transfer as heat during that part of the cycle (=). Energy transfer is considered as work done by the system only. Isothermal : The process is at a constant temperature during that part of the cycle (=, =). Energy transfer is considered as heat removed from or work done by the system.
Here, is the overall heat transfer coefficient, is the total heat transfer area, and is the minimum heat capacity rate. To better understand where this definition of NTU comes from, consider the following heat transfer energy balance, which is an extension of the energy balance above:
Heat is the flow of thermal energy driven by thermal non-equilibrium, so the term 'heat flow' is a redundancy (i.e. a pleonasm). Heat must not be confused with stored thermal energy, and moving a hot object from one place to another must not be called heat transfer. However, it is common to say ‘heat flow’ to mean ‘heat content’. [1]
In the case of heat transfer by thermal radiation, Newton's law of cooling holds only for very small temperature differences. When stated in terms of temperature differences, Newton's law (with several further simplifying assumptions, such as a low Biot number and a temperature-independent heat capacity ) results in a simple differential ...