Search results
Results From The WOW.Com Content Network
The tradition also served a functional purpose: a pine tree was used, and after the needles had fallen off the tree, the builders knew the wood frame below had cured/dried out so they could enclose the building. [4] Long an important component of timber frame building, [5] it migrated initially to England and Northern Europe, thence to the ...
The central "web" of the steel I-beam is often wider than a column web to resist the higher bending moments that occur in beams. Wide sheets of steel deck can be used to cover the top of the steel frame as a "form" or corrugated mold, below a thick layer of concrete and steel reinforcing bars. Another popular alternative is a floor of precast ...
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Frame of the Crystal Palace. Beams and girders were made of wrought iron with I-beam cross-section. The material was rarely used for the columns, as the cast was both stronger under compression and cheaper, so a typical iron frame building in the second half of the 19th century had cast iron columns and wrought iron beams.
A bent in American English is a transverse rigid frame (or similar structures such as three-hinged arches).Historically, bents were a common way of making a timber frame; they are still often used for such, and are also seen in small steel-frame buildings, where the term portal frame is more commonly used.
Portal frame is a construction technique where vertical supports are connected to horizontal beams or trusses via fixed joints with designed-in moment-resisting capacity. [1] The result is wide spans and open floors. Portal frame structures can be constructed using a variety of materials and methods. These include steel, reinforced concrete and ...
Channel or C section girts bolted to plate cleats welded to a portal column in an industrial building. In architecture or structural engineering, a girt, also known as a sheeting rail, is a horizontal structural member in a framed wall. Girts provide lateral support to the wall panel, primarily to resist wind loads. [citation needed]
An elaborate cast iron frame was used for the dome of Saint Isaac's Cathedral in St Petersburg (1837–38), and the new roof following a fire of Chartes Cathedral (also 1837–8, and the widest span of a metal roof at the time). Similarly large span beams were also to support the wide roofs of the Palace of Westminster (1840s–50s).