Ad
related to: gigabit ethernet driver windows 10 dell keyboard
Search results
Results From The WOW.Com Content Network
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
At the time that the 10 Gigabit Ethernet standard was developed, interest in 10GbE as a wide area network (WAN) transport led to the introduction of a WAN PHY for 10GbE. The WAN PHY was designed to interoperate with OC-192/STM-64 SDH/SONET equipment using a light-weight SDH/SONET frame running at 9.953 Gbit/s.
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
The PCM8428 is the only full Fibre Channel over Ethernet capable switch for the M1000e enclosure that offers 16 x enhanced Ethernet 10 Gb internal interfaces, 8 x 10 Gb (enhanced) Ethernet external ports and also up to four 8 Gb Fibre Channel interfaces to connect directly to a FC SAN controller or central Fibre Channel switch.
DisplayLink Corp. (formerly Newnham Research) is a semiconductor and software technology company. It specializes in developing DisplayLink USB graphics technology, enabling connections between computers and displays via USB, Ethernet, and WiFi.
By bonding the connections from multiple Ethernet ports via IEEE 802.3ad link aggregation or similar, manufacturers were able to achieve speeds close to 2 Gbit/s by using two ports that support gigabit speeds. This would require the wireless access point to be connected to the rest of the network with 2 Ethernet cables and require both the ...
The Killer NIC (Network Interface Card), from Killer Gaming (now a subsidiary of Intel Corporation), is designed to circumvent the Microsoft Windows TCP/IP stack, and handle processing on the card via a dedicated network processor. Most standard network cards are host based, and make use of the primary CPU.
To further reduce power consumption, the link speed is usually reduced to the lowest possible speed (e.g. a Gigabit Ethernet NIC maintains only a 10 Mbit/s link). Disabling Wake-on-LAN, when not needed, can slightly reduce power consumption on computers that are switched off but still plugged into a power socket. [6]