Search results
Results From The WOW.Com Content Network
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
≡ 1 ft/(h⋅s) = 8.4 6 × 10 −5 m/s 2: foot per minute per second: fpm/s ≡ 1 ft/(min⋅s) = 5.08 × 10 −3 m/s 2: foot per second squared: fps 2: ≡ 1 ft/s 2 = 3.048 × 10 −1 m/s 2: gal; galileo: Gal ≡ 1 cm/s 2 = 10 −2 m/s 2: inch per minute per second: ipm/s ≡ 1 in/(min⋅s) = 4.2 3 × 10 −4 m/s 2: inch per second squared ...
Because of the identity property of multiplication, multiplying any quantity (physical or not) by the dimensionless 1 does not change that quantity. [5] Once this and the conversion factor for seconds per hour have been multiplied by the original fraction to cancel out the units mile and hour, 10 miles per hour converts to 4.4704 metres per second.
This is approximately 1 / 8 inch per mile; 12.7 kilometres is exactly 500,000 standard inches and exactly 499,999 survey inches. This difference is substantial when doing calculations in State Plane Coordinate Systems with coordinate values in the hundreds of thousands or millions of feet.
One metre is exactly equivalent to 5 000 / 127 inches and to 1 250 / 1 143 yards. A simple mnemonic to assist with conversion is "three 3s": 1 metre is nearly equivalent to 3 feet 3 + 3 ⁄ 8 inches. This gives an overestimate of 0.125 mm. The ancient Egyptian cubit was about 0.5 m (surviving rods are 523–529 mm). [154]
The Greek foot (πούς, pous) had a length of 1 / 600 of a stadion, [12] one stadion being about 181.2 m (594 ft); [13] therefore a foot was, at the time, about 302 mm (11.9 in). Its exact size varied from city to city and could range between 270 mm (10.6 in) and 350 mm (13.8 in), but lengths used for temple construction appear to ...
This translates to a hoppus foot being equal to 1.273 cubic feet (2,200 in 3; 0.0360 m 3). The hoppus board foot, when milled, yields about one board foot. The volume yielded by the quarter-girth formula is 78.54% of cubic measure (i.e. 1 ft 3 = 0.7854 h ft; 1 h ft = 1.273 ft 3). [42]
1 cm – 0.39 inches; 1 cm – edge of a square of area 1 cm 2; 1 cm – edge of a cube of volume 1 mL; 1 cm – length of a coffee bean; 1 cm – approximate width of average fingernail; 1.2 cm – length of a bee; 1.2 cm – diameter of a die; 1.5 cm – length of a very large mosquito; 1.6 cm – length of a Jaragua Sphaero, a very small reptile