Ads
related to: full wave vs half antenna power inverter for home audio system ideas
Search results
Results From The WOW.Com Content Network
The most common type of dipole consists of two resonant elements, each just under a quarter wavelength long, hence a total length of about a half-wave. This antenna radiates maximally in directions perpendicular to the antenna's axis, giving it a small directive gain of 2.15 dBi (2.15 dBi means that in the direction of maximum radiation, signal ...
German physicist Heinrich Hertz first demonstrated the existence of radio waves in 1887 using what we now know as a dipole antenna (with capacitative end-loading). On the other hand, Guglielmo Marconi empirically found that he could just ground the transmitter (or one side of a transmission line, if used) dispensing with one half of the antenna, thus realizing the vertical or monopole antenna.
A full-wave loop antenna is slightly more than two half-wavelengths in circumference, which is a bit more than double the size of a halo antenna designed to operate on the same frequency. In contrast, the two semi-circles of a resonant loop, each is a half wavelength long.
In some cases, an audio device may be measured by the total system power of all its loudspeakers by adding all their peak power ratings. Many home theater in a box systems are rated this way. Often low-end home theater systems' power ratings are taken at a high level of harmonic distortion as well; as high as 10%, which would be noticeable. [21]
The coaxial collinear (COCO) antenna uses transposed coaxial sections to produce in-phase half-wavelength radiators. [5] A Franklin array uses short U-shaped half-wavelength sections whose radiation cancels in the far-field to bring each half-wavelength dipole section into equal phase. Another type is the omnidirectional microstrip antenna (OMA ...
Here especially, impedance-matching volume controls can be used to protect the amplifier from overload. This system design is otherwise the same as a single source, single zone in that all zones must listen to the same audio source, though volume control is independent in each room (and audio can be turned off in rooms, as desired).