Search results
Results From The WOW.Com Content Network
The 4.3-10 connector (sometimes referred to as 4.3/10) is a 50 Ω multi-purpose RF connector used to connect coaxial cables with other cables or RF devices, such as transmitters or antennas. The IEC standard 61169-54 specifies an inner diameter of the outer conductor is 10 mm and the outer diameter of the inner conductor is 4.3 mm.
Transactions for Unix, Extended for Distributed Operations developed by AT&T Corporation, now owned by Oracle Corporation. Tuxedo is a cross-platform TPS. UNIVAC Transaction Interface Package (TIP) – 1970s. A transaction processing monitor for UNIVAC 1100/2200 series computers. [3]
VCRs, DVD recorders, etc. act as a "pass-through" for composite video and S-video, though sometimes they act as an RF modulator for use on Channel 3. Tape monitor features allow an AV receiver (sometime the recording device itself) to act as a "pass-through" for audio. An AV receiver usually allows pass-through of the video signal while ...
One of the principle advantages of this type of code is that it can eliminate any DC component. This is important if the signal must pass through a transformer or a long transmission line. Unfortunately, several long-distance communication channels have polarity ambiguity. Polarity-insensitive line codes compensate in these channels.
Total latency of one 4-beat burst mode = (t initial + t sequential) = 8 + 4x(0.5) = 10 ns For 32 write transactions, required 4-beat transfers = 32/4 = 8 Hence, total latency of 32 write transfers = 10 x 8 = 80 ns Total throughput increase factor using 4-beat burst mode = single mode latency/(total burst mode latency) = 272/80 = 3.4
[4] [failed verification] SAT-3 was finalized in 2014, and SAT-4 in 2016. Since the standards have become ANSI standards, the drafts are inaccessible to the public. SAT-4 added a 32-byte ATA PASS-THROUGH command. [5] This version of the command support additional AUXILIARY and ICC fields used by some ATA commands. [6] Work on SAT-5 began in 2017.
[3] In October 2016, Huawei announced that it had achieved 27 Gbit/s in 5G field trial tests using polar codes for channel coding. The improvements have been introduced so that the channel performance has now almost closed the gap to the Shannon limit, which sets the bar for the maximum rate for a given bandwidth and a given noise level. [4]
A passthrough device is a device used in conjunction with a computer to reprogram vehicle control modules through the OBD-II/CANbus port. [1] Each manufacturer has their own type, but SAE International standardized the J-2534 universal requirements in 2004, requiring all manufacturers to allow vehicles sold in the United States of America and Europe to accept powertrain reprogramming through ...