Search results
Results From The WOW.Com Content Network
The Ford C3 transmission and its descendants are a family of light-duty longitudinal automatic transmissions built by the Ford Motor Company.. The Bordeaux Automatic Transmission Plant, in Blanquefort, France (in the Bordeaux metropolitan area) produces automatic transmissions for a variety of rear-wheel drive vehicles.
These are dual-clutch transmissions. 2008–present 6DCT 150 6-speed wet clutch. Ford Fiesta; 2008–present 6DCT 250 (DPS6) 6-speed dry clutch. Ford EcoSport, Ford Fiesta, Ford Focus. The 2012-2016 DPS6 Powershift transmission was used in the 2012–2016 Ford Focus and 2011–2016 Ford Fiesta sedans. This transmission is the subject of a ...
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
There are two types of clutch screw drives: Type G and Type A (Type G was patented and introduced before Type A). Type A, also known as a "standard clutch", resembles a bow tie, with a small circular "knot" at the center. These were common in GM automobiles, trucks and buses of the 1940s and 1950s.
Although not strictly a part of classic torque converter design, many automotive converters include a lock-up clutch to improve cruising power transmission efficiency and reduce heat. The application of the clutch locks the turbine to the impeller, causing all power transmission to be mechanical, thus eliminating losses associated with fluid drive.
A cone clutch serves the same purpose as a disk or plate clutch; however, instead of mating two spinning disks, the cone clutch uses two conical surfaces to transmit torque by friction. [1] The cone clutch transfers a higher torque than plate or disk clutches of the same size due to the wedging action and increased surface area.
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation: