Search results
Results From The WOW.Com Content Network
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
The Dodge Nitro is a compact SUV [3] [4] manufactured and marketed by Dodge for model years 2007–2012 across a single generation — as a close variant of the second-generation Jeep Liberty. Both vehicles use a composite unitized construction integrating the body structure with full-length frame rails.
The 3.5 L engine was expanded to 4.0 L; 241.2 cu in (3,952 cc) for the 2007 Dodge Nitro and Chrysler Pacifica. Like its family members, this is a SOHC engine and was built in Trenton, Michigan . DaimlerChrysler reportedly spent $155 million to expand the Trenton plant to manufacture this engine.
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
They may live thousands of miles apart but Sheryl Lee Ralph and husband Vincent Hughes have been on the same page for decades.. The Abbott Elementary star, 69, opens up to PEOPLE in this week's ...
Engine flooding was a common problem with carbureted cars, but newer fuel-injected ones are immune to the problem when operating within normal tolerances. Flooding usually occurs during starting, especially under cold conditions or because the accelerator has been pumped. It can also occur during hot starting; high temperatures may cause fuel ...
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942 The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3]
Compression tests should normally be done with all spark plugs removed to maximize cranking speed. Cranking compression is a dynamic test of the actual low-speed pumping action, where peak cylinder pressure is measured and stored. A compression tester. Leak-down testing is a static test. Leak-down tests cylinder leakage paths.