Ad
related to: decimal ft to and inches
Search results
Results From The WOW.Com Content Network
The foot (standard symbol: ft) [1] [2] is a unit of length in the British imperial and United States customary systems of measurement. The prime symbol, ′, is commonly used to represent the foot. [3] In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet.
The following table lists the units of the Jeffersonian decimal system, and their relationship with one another. The values of these units are based on Jefferson's proposal of a foot that was equal in length to one-fifth of a second rod, one fourth of an inch shorter than the foot in use at the time, and approximately equal to 0.298461684 m. [5]
(Furlongs remained the same, but the rod changed from 15 old feet to 16 1 ⁄ 2 new feet. [10]) In 1324 Edward II systematized units of length by defining the inch as 3 barleycorns, the foot as 12 inches, the yard as 3 feet, the perch as 5 1 ⁄ 2 yards, and the acre as an area 4 by 40 perches. [2]
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
American surveyors use a decimal-based system of measurement devised by Edmund Gunter in 1620. The base unit is Gunter's chain of 66 feet (20 m) which is subdivided into 4 rods, each of 16.5 ft or 100 links of 0.66 feet. A link is abbreviated "lk", and links "lks", in old deeds and land surveys done for the government.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output. For example, if the output is "in hand", the inches value is rounded independently from the hands value.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
A value in decimal degrees to 5 decimal places is precise to 1.11 metres (3 ft 8 in) at the equator. Elevation also introduces a small error: at 6,378 metres (20,925 ft) elevation, the radius and surface distance is increased by 0.001 or 0.1%.