Ads
related to: how to replace distributor s-10
Search results
Results From The WOW.Com Content Network
The Chevrolet S-10 is a compact pickup truck produced by Chevrolet.It was the first domestically-built compact pickup of the big three American automakers. When it was first introduced as a "quarter-ton pickup" in 1981 for the 1982 model year, the GMC version was known as the S-15 and later renamed the GMC Sonoma.
The first iteration of the 305, the LG3 was introduced in 1976. This variant used a Rochester 2GC carburetor from 1976 to 1978. In 1979, the more fuel-efficient Rochester Dual-Jet two-barrel carburetor replaced the older 2GC. This change also resulted in a drop in power to 130 hp (97 kW) and 125 hp (93 kW) for California emissions cars.
A distributor consists of a rotating arm ('rotor') that is attached to the top of a rotating 'distributor shaft'. The rotor constantly receives high-voltage electricity from an ignition coil via brushes at the centre of the rotor. As the rotor spins, its tip passes close to (but does not touch) the output contacts for each cylinder.
The contact breaker is operated by an engine-driven cam.On an engine with a distributor, the contact breaker can be found beneath the distributor cap.The position of the contact breaker is set so that it opens (and hence generates a spark) at exactly the optimum moment to ignite the fuel/air mixture.
HEI distributors are a popular swap on older GM cars originally equipped with points and condenser type ignition systems. [citation needed] The HEI system produces a more powerful spark, which allows for a wider spark plug gap for surer ignition of a fuel/air mix that may not be optimal. The HEI setup has also become a popular swap into non-GM ...
Before electronic crank sensors were available, the distributor would have to be manually adjusted to a timing mark on petrol engines. The crank sensor can be used in combination with a similar camshaft position sensor (CMP) [ 4 ] [ 5 ] [ 3 ] to monitor the relationship between the pistons and valves in the engine, which is particularly ...
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
General Motors started with a regular-cab, short-box (6-foot (180 cm) bed) S-10 pickup, with a base-level trim package plus a half-tonneau cover. In place of a typical inline four cylinder or V-6 internal combustion engine, the Electric S-10 EV was equipped with an 85-kilowatt (114 hp) three-phase, liquid-cooled AC induction motor, based on GM's EV1 electric coupe.