When.com Web Search

  1. Ads

    related to: best kitchen sink taps uk only one side goes

Search results

  1. Results From The WOW.Com Content Network
  2. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    The most common plumbing fixtures are: Bathtubs; Bidets; Channel drains; Drinking fountains; Showers; Sinks; Tap (connections for water hoses) . Tapware - an industry term for that sub-category of plumbing fixtures consisting of tap valves, also called water taps (British English) or faucets (American English), and their accessories, such as water spouts and shower heads.

  3. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Taps are normally connected to the water supply by means of a "swivel tap connector", which is attached to the end of the water pipe using a soldered or compression fitting, and has a large nut to screw onto the threaded "tail" of the tap, which hangs down underneath the bath, basin or sink.

  4. Sink - Wikipedia

    en.wikipedia.org/wiki/Sink

    A sink/basin in a bathroom Enamel washbowl and jug Sink in Croatian National Theater in Zagreb, Croatia. A sink (also known as basin in the UK) is a bowl-shaped plumbing fixture for washing hands, dishwashing, and other purposes. Sinks have a tap (faucet) that supplies hot and cold water and may include a spray feature

  5. Tap water - Wikipedia

    en.wikipedia.org/wiki/Tap_water

    An outdoor drinking water tap at Desa Dasan Geria Village, West Lombok. Everything in a building that uses water falls under one of two categories; fixture or appliance. As the consumption points above perform their function, most produce waste/sewage components that will require removal by the waste/sewage side of the system.

  6. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...

  7. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    The U-bend could not jam, so, unlike the S-bend, it did not need an overflow. In the United States, traps are commonly referred to as P-traps. It is the addition of a 90 degree fitting on the outlet side of a U-bend, thereby creating a P-like shape (oriented horizontally). It is also referred to as a sink trap because it is installed under most ...