Search results
Results From The WOW.Com Content Network
The "Scope" soldering iron is a tool for soldering with lead-tin alloys, made in Australia since 1950, and intended for occasional or intermittent use.It has the virtue of quickly coming up to soldering temperature (~300C) and delivering considerable heat to a small area, but requires care to avoid overheating.
The split tip of a ColdHeat soldering iron. The first two products were soldering irons powered by alkaline batteries.The manufacturer claims this soldering iron is unique in that its Athalite tip undergoes a temperature change from ambient temperature to approximately 800 °F (427 °C) and back to ambient within three seconds when the tip is removed from the work.
Anything with a base unit with provision to maintain a stable temperature, pump air in either direction, etc., is often called a "station" (preceded by rework, soldering, desoldering, hot air); one, or sometimes more, tools may be connected to a station, e.g., a rework station may accommodate a soldering iron and hot air head. A soldering iron ...
A soldering station has a temperature control and consists of an electrical power supply, control circuitry with provision for user adjustment of temperature and display, and a soldering iron or soldering head with a tip temperature sensor. The station will normally have a stand for the hot iron when not in use, and a wet sponge for cleaning.
Lithium iron phosphate modules, each 700 Ah, 3.25 V. Two modules are wired in parallel to create a single 3.25 V 1400 Ah battery pack with a capacity of 4.55 kWh. Cell voltage Minimum discharge voltage = 2.0-2.8 V [27] [28] [29] Working voltage = 3.0 ~ 3.3 V; Maximum charge voltage = 3.60-3.65 V [30] [28] Volumetric energy density = 220 Wh/L ...
A tube of multicore electronics solder used for manual soldering. For attachment of electronic components to a PCB, proper selection and use of flux helps prevent oxidation during soldering; it is essential for good wetting and heat transfer. The soldering iron tip must be clean and pre-tinned with solder to ensure rapid heat transfer.
Although solder paste typically contains around 90% metal in solids by weight, the volume of the soldered joint is only about half that of the solder paste applied. [7] This is due to the presence of flux and other non-metallic agents in the paste, and the lower density of the metal particles when suspended in the paste as compared to the final ...
A 1948 advertisement for a Weller soldering gun. Pistol-grip electrically-heated soldering tools had been used since the 1920s. In 1941 Carl E. Weller invented and later obtained U.S. patent 2,405,866 [1] for a transformer-based soldering tool which heated and cooled rapidly, [2] essentially as described in this article. Weller formed a company ...