When.com Web Search

  1. Ads

    related to: 1 5 8 long socket wrench dimensions table

Search results

  1. Results From The WOW.Com Content Network
  2. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

  3. Socket wrench - Wikipedia

    en.wikipedia.org/wiki/Socket_wrench

    A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt. [2] The most prevalent form is the ratcheting socket wrench, often informally called a ratchet.

  4. British Standard Whitworth - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Whitworth

    Two spanners, both nominal size 58 in, with a diagram superimposed to show the logic that allows them both to be nominal size 58 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats definition is the common standard today, and has been for many decades.

  5. Wrench - Wikipedia

    en.wikipedia.org/wiki/Wrench

    A type of wrench designed to use the same drive sizes as socket wrenches, but non-cylindrical in shape. The ends are the same as those found on the open-end, box-end, or the flare-nut wrenches. These wrenches are used when torque must be measured, or when the application precludes the use of a regular socket or wrench.

  6. These Standardized Socket Sets Make Short Work of Auto and ...

    www.aol.com/lifestyle/standardized-socket-sets...

    For premium support please call: 800-290-4726 more ways to reach us

  7. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.