Ads
related to: bridged mono vs mono beam wire harness reviews
Search results
Results From The WOW.Com Content Network
A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications. [1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed.
This includes the original 6.35mm (quarter inch) jack and the more recent and standard 3.5mm (miniature or 1/8 inch) and 2.5mm (subminiature) jacks, both mono and stereo (balanced) versions. [2] XLR connectors, also known as Cannon plugs, used for analog or digital balanced audio with a balanced line. Digital audio interfaces and interconnects:
A diagram of monaural sound. Monaural sound or monophonic sound (often shortened to mono) is sound intended to be heard as if it were emanating from one position. [1] This contrasts with stereophonic sound or stereo, which uses two separate audio channels to reproduce sound from two microphones on the right and left side, which is reproduced with two separate loudspeakers to give a sense of ...
A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]
Lattice and bridged-T equalizers are circuits which are used to correct for the amplitude and/or phase errors of a network or transmission line. Usually, the aim is to achieve an overall system performance with a flat amplitude response and constant delay over a prescribed frequency range, [ 1 ] : 128 [ 2 ] : 679 by the addition of an equalizer.
Point-to-point wiring is not suitable for automated assembly (though see wire wrap, a similar method that is) and is carried out manually, making it both more expensive and more susceptible to wiring errors than PCBs, as connections are determined by the person doing assembly rather than by an etched circuit board.
These include providing a signal sample for measurement or monitoring, feedback, combining feeds to and from antennas, antenna beam forming, providing taps for cable distributed systems such as cable TV, and separating transmitted and received signals on telephone lines.
A bridgewire or bridge wire, also known as a hot bridge wire (HBW), is a relatively thin resistance wire used to set off a pyrotechnic composition serving as pyrotechnic initiator. By passing of electric current it is heated to a high temperature that starts the exothermic chemical reaction of the attached composition.