Search results
Results From The WOW.Com Content Network
The ability to convert data from serial to parallel, and from parallel to serial, using shift registers. An on-chip bit rate (baud rate) generator to control transmit and receive data rate. Handshake lines for control of an external modem, controllable by software. An interrupt function to the host microprocessor.
An example of an early 1980s UART was the National Semiconductor 8250 used in the original IBM PC's Asynchronous Communications Adapter card. [5] In the 1990s, newer UARTs were developed with on-chip buffers. This allowed higher transmission speed without data loss and without requiring such frequent attention from the computer.
The last data bit is sometimes used as a parity bit. The number of data and formatting bits, the order of data bits, the presence or absence of a parity bit, the form of parity (even or odd) and the transmission speed must be pre-agreed by the communicating parties. The "stop bit" is actually a "stop period"; the stop period of the transmitter ...
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
I 2 C uses only two signals: serial data line (SDA) and serial clock line (SCL). Both are bidirectional and pulled up with resistors. [3] Typical voltages used are +5 V or +3.3 V, although systems with other voltages are permitted. The I 2 C reference design has a 7-bit address space, with a rarely used 10-bit extension. [4]
After all bits have been shifted out and in, the main and sub have exchanged register values. If more data needs to be exchanged, the shift registers are reloaded and the process repeats. Transmission may continue for any number of clock cycles. When complete, the main stops toggling the clock signal, and typically deselects the sub.
In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data. It formally defines signals connecting between a DTE ( data terminal equipment ) such as a computer terminal or PC , and a DCE ( data circuit-terminating equipment or data communication ...