When.com Web Search

  1. Ads

    related to: engine interference belt repair

Search results

  1. Results From The WOW.Com Content Network
  2. Interference engine - Wikipedia

    en.wikipedia.org/wiki/Interference_engine

    If a timing belt or chain breaks in an interference engine, mechanics check for bent valves by performing a leak-down test of each cylinder or by checking the valve gaps. A very large valve gap points to a bent valve. Repair options depend on the extent of the damage. If the pistons and cylinders are damaged, the engine must be rebuilt or replaced.

  3. Volvo Redblock Engine - Wikipedia

    en.wikipedia.org/wiki/Volvo_Redblock_Engine

    Another cause for timing belt failure is improperly adjusting the timing belt on engines with a manual tensioner (1989 to very early 1990 models only) or improperly adjusting the balance shaft belt. Because this is an interference engine, damage will occur if the timing belt fails. Another common occurrence is that the balance shaft's oil seals ...

  4. Overhead camshaft engine - Wikipedia

    en.wikipedia.org/wiki/Overhead_camshaft_engine

    [11]: 94–95 [12]: 250 If the timing belt is not replaced in time and fails and the engine is an interference engine, major engine damage is possible. The first known automotive application of timing belts to drive overhead camshafts was the 1953 Devin-Panhard racing specials built for the SCCA H-modified racing series in the United States.

  5. Timing belt (camshaft) - Wikipedia

    en.wikipedia.org/wiki/Timing_belt_(camshaft)

    The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s and compared to timing chains are less expensive, smaller, lighter, quieter ...

  6. Chrysler SOHC V6 engine - Wikipedia

    en.wikipedia.org/wiki/Chrysler_SOHC_V6_engine

    1993–97 3.5 L engines are a non-interference design, in which the valves will not collide with the pistons in the event of a timing belt failure. The 1998–2001 3.2 L, the 1998–2010 3.5 L, and the 2007–2011 4.0 L engines are interference designs.

  7. Toyota S engine - Wikipedia

    en.wikipedia.org/wiki/Toyota_S_engine

    This is commonly referred to as a "non-interference" engine. Piston pins holding the pistons in place are locked by snap rings. The "Outer Shim Type System" allows for the replacement of the shims without the need to remove the camshaft. To adjust the valve clearance, adjust the shims above the valve lifters.