Search results
Results From The WOW.Com Content Network
Main Wikipedia article: Electrical generator Description: Dynamos are no longer used for power generation due to the size and complexity of the commutator needed for high power applications. This large belt-driven high-current dynamo produced 310 amperes at 7 volts, or 2,170 watts, when spinning at 1400 RPM.
The largest air-insulated Van de Graaff generator in the world, built by Dr. Van de Graaff in the 1930s, is now displayed permanently at Boston's Museum of Science. With two conjoined 4.5 m (15 ft) aluminium spheres standing on columns 22 ft (6.7 m) tall, this generator can often obtain 2 MV (2 million volts).
English: Diagram of revolving-field single phase generator with two poles. As the rotor turns, the lines of force at two poles are cut by the coils inducing current. The output from two coils are "in phase". The direction of current changes to the opposite site every 180 degrees of rotation.
In 1891, a 3,000 volts and 133 Hz single-phase generator of 100 horsepower was installed at Ames Hydroelectric Generating Plant which was belt-connected with Pelton water wheel. The power was transmitted through 4.2 kilometres (2.6 mi) cables to power an identical motor at the mill.
A homopolar generator is a DC electrical generator comprising an electrically conductive disc or cylinder rotating in a plane perpendicular to a uniform static magnetic field. A potential difference is created between the center of the disc and the rim (or ends of the cylinder) with an electrical polarity that depends on the direction of ...
As an example, a 250 kVA motor–generator operating at 300 ampere of full load current will require 1550 ampere of in-rush current during a re-closure after 5 seconds. This example used a fixed mounted flywheel sized to result in a 1 ⁄ 2 Hz per second slew rate. The motor–generator was a vertical type two-bearing machine with oil-bath ...
Before shaft alignment can be done, the foundations for the driver and the driven piece must be designed and installed correctly. [citation needed]Flexible couplings are designed to allow a driver (e.g., electric motor, engine, turbine, hydraulic motor) to be connected to the driven equipment.
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...