Search results
Results From The WOW.Com Content Network
Standard Maximum Link Rate Year ... Serial RS-232 max: 230.4 kbit/s: 28.8 ... The table below shows values for PC memory module types.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
The speed (or baud rate) includes bits for framing (stop bits, parity, etc.), thus the effective data rate is lower than the baud rate. For 8-N-1 encoding, only 80% of the bits are available for data (for every eight bits of data, ten bits are sent over the serial link — one start bit, the eight data bits, and the one stop bit).
For example, in a 64QAM modem, M = 64, and so the bit rate is N = log 2 (64) = 6 times the baud rate. In a line code, these may be M different voltage levels. The ratio is not necessarily an integer; in 4B3T coding, the bit rate is 4 / 3 of the baud rate. (A typical basic rate interface with a 160 kbit/s raw data rate operates at 120 kBd.)
This UART has 16-byte FIFO buffers. Its receive interrupt trigger levels can be set to 1, 4, 8, or 14 characters. Its maximum standard serial port speed if the operating system has a 1 millisecond interrupt latency is 128 kbit/s. Systems with lower interrupt latencies or with DMA controllers could handle higher baud rates.
The maximum working length of a cable varies depending on the characteristics of the transmitters and receivers, the baud rate on the cable, and the capacitance and electrical impedance of the cable. The RS-232 standard states that a compliant port must provide defined signal characteristics for a capacitive load of 2500 pF. This does not ...
The speed or bits per second of the line (equal to the Baud rate when each symbol represents one bit). Some systems use automatic speed detection, also called automatic baud rate detection. Whether to use or not use parity; Odd or even parity, if used; The number of stop bits sent must be chosen (the number sent must be at least what the ...
For this reason, the baud rate value will often be lower than the gross bit rate. Example of use and misuse of "baud rate": It is correct to write "the baud rate of my COM port is 9,600" if we mean that the bit rate is 9,600 bit/s, since there is one bit per symbol in this case. It is not correct to write "the baud rate of Ethernet is 100 ...