Ad
related to: gas stove pilot light out reset button on furnace panel door switch
Search results
Results From The WOW.Com Content Network
The thermocouple sensor detects the heat from the pilot light and sends a signal to keep the gas valve open, but if the pilot light is extinguished, then the thermocouple will send a signal to the ...
For gas appliances, a flame supervision device (FSD) – alternative name: flame failure device (FFD) – is a general term for any device designed to stop flammable gas going to the burner of a gas appliance if the flame is extinguished. This is to prevent a dangerous buildup of gas within the appliance, its chimney or the room. [1]
In natural gas furnaces, water heaters, and room heating systems, a safety cut-off switch is normally included so that the gas supply to the pilot and heating system is shut off by an electrically operated valve if the pilot light goes out. This cut-off switch usually detects the pilot light in one of several ways: A flame rectification device. [2]
Gas stoves today use two basic types of ignition sources, standing pilot and electric. [21] A stove with a standing pilot has a small, continuously burning gas flame (called a pilot light) under the cooktop. [21] The flame is between the front and back burners. When the stove is turned on, this flame lights the gas flowing out of the burners.
Auto reignition lowers the risk of gas leaks: if a flame goes out during operation, for example, from vibration or a gust of wind; due to misoperation—a user might not understand the "light" position must be maintained for about 0.5 to 2 seconds before turning the burner knob on fully.
The gas lighter is mostly cylindrical in shape and consists of a piezo-electric crystal over which a spring-loaded hammer is placed. The hammer and spring set up is attached to a button. When this button is pressed, the hammer is moved away from the piezo-electric crystal. When the button is pressed over a limit, the spring releases the hammer.
A thermal switch (sometimes thermal reset or thermal cutout (TCO)) is a device which normally opens at a high temperature (often with a faint "plink" sound) and re-closes when the temperature drops. The thermal switch may be a bimetallic strip , often encased in a tubular glass bulb to protect it from dust or short circuit .
The illustration is the interior of a common two wire heat-only household thermostat, used to regulate a gas-fired heater via an electric gas valve. Similar mechanisms may also be used to control oil furnaces, boilers, boiler zone valves , electric attic fans, electric furnaces, electric baseboard heaters, and household appliances such as ...