When.com Web Search

  1. Ads

    related to: japan fender stratocaster bridge screws stainless steel

Search results

  1. Results From The WOW.Com Content Network
  2. Fender Contemporary Stratocaster Japan - Wikipedia

    en.wikipedia.org/wiki/Fender_Contemporary...

    The System 1 bridge can be replaced successfully with a Floyd Rose licensed bridge. The slightly wider pivot screw spacing of the System 1 bridge needs a Floyd Rose licensed bridge design with one pivot screw cutaway that extends to the edge of the bridge allowing the Floyd Rose licensed bridge to mount onto the System 1 pivot screws.

  3. Squier '51 - Wikipedia

    en.wikipedia.org/wiki/Squier_'51

    The neck is essentially that of a Fender Telecaster, with same square heel and peg head designs. The bridge is a top-loaded hardtail plate secured by 5 screws, with 6 cast metal saddles on a 2 1/16" E-to-e spacing. The '51 uses a humbucker pickup in the bridge position and a single-coil (R≈3.5kΩ) pickup in the

  4. Fender Bullet - Wikipedia

    en.wikipedia.org/wiki/Fender_Bullet

    A hard tail bridge and later a six screw vintage style trem bridge was offered. The guitars featured 3 Single coils or 2 Humbucking pickups like the original USA-made "Bullet" guitars, but steel rods were used as pole pieces with a ceramic bar magnet; the humbucker version consisted of the same paired single coil configuration as the American ...

  5. Vibrato systems for guitar - Wikipedia

    en.wikipedia.org/wiki/Vibrato_systems_for_guitar

    Featuring stainless steel block saddles since its introduction in 1986, the Fender two-point system has been redesigned with new vintage-style bent sheet steel saddles as of 2008. The Fender two-point system is available with two types of "tremolo bars": traditional "screw-in" type with a plastic tip at the end and deluxe "pop-in" type without ...

  6. Fender Lead Series - Wikipedia

    en.wikipedia.org/wiki/Fender_Lead_Series

    The X-1 pickup was also used in the bridge position on the "STRAT" and the "Dan Smith Stratocaster" models. Three-position pickup selector switch (neck, neck and bridge, bridge), two-position phase shift switch (in phase, out of phase) which operates only when both pickups are selected (middle position). Master volume and tone controls.

  7. Fender Japan - Wikipedia

    en.wikipedia.org/wiki/Fender_Japan

    Some FujiGen-made Fender Japan models between 1982 and 1996 have necks made by Atlansia. Dyna Gakki took over the manufacture of the Fender Japan models in 1996/1997. The Tōkai-made Fender Japan guitars made for a few months while Dyna got up to speed were not exported. Terada made the Fender Japan acoustic guitars such as the Fender Catalina.