Search results
Results From The WOW.Com Content Network
Parallel resistance is illustrated by the circulatory system. Each organ is supplied by an artery that branches off the aorta. The total resistance of this parallel arrangement is expressed by the following equation: 1/R total = 1/R a + 1/R b + ... + 1/R n. R a, R b, and R n are the resistances of the renal, hepatic, and other arteries ...
Serial communication is used for all long-haul communication and most computer networks, where the cost of cable and difficulty of synchronization make parallel communication impractical. Serial computer buses have become more common even at shorter distances, as improved signal integrity and transmission speeds in newer serial technologies ...
Parallel versus serial communication In data transmission , parallel communication is a method of conveying multiple binary digits ( bits ) simultaneously using multiple conductors. This contrasts with serial communication , which conveys only a single bit at a time; this distinction is one way of characterizing a communications link .
While specific examples follow, countless other connectors have been used for RS-232 connections. The 9-pin DE-9 connector has been used by most IBM-compatible PCs since the Serial/Parallel Adapter option for the PC-AT, where the 9-pin connector allowed a serial and parallel port to fit on the same card. [4]
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
The PISO (Parallel Input, Serial Output) block typically has a parallel clock input, a set of data input lines, and input data latches. It may use an internal or external phase-locked loop (PLL) to multiply the incoming parallel clock up to the serial frequency.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
In general, parallel interfaces are quoted in B/s and serial in bit/s. The more commonly used is shown below in bold type. On devices like modems , bytes may be more than 8 bits long because they may be individually padded out with additional start and stop bits; the figures below will reflect this.