Search results
Results From The WOW.Com Content Network
The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.
Cisco Express Forwarding (CEF) is an advanced layer 3 switching technology used mainly in large core networks or the Internet to enhance the overall network performance. . Although CEF is a Cisco proprietary protocol other vendors of multi-layer switches or high-capacity routers offer a similar functionality where layer-3 switching or routing is done in hardware (in an ASIC) instead of by ...
Label of a UMTS router with MAC addresses for LAN and WLAN modules. A MAC address (short for medium access control address or media access control address) is a unique identifier assigned to a network interface controller (NIC) for use as a network address in communications within a network segment.
Cisco VIP 2-40, from an older generation of routers. Performance Route Processor, from the high-end Cisco 12000 series.. In routing, the data plane, sometimes called the forwarding plane or user plane, defines the part of the router architecture that decides what to do with packets arriving on an inbound interface.
This address is used by only one physical router at a time, and it will reply with this MAC address when an ARP request is sent for the virtual router's IP address. Physical routers within the virtual router must communicate within themselves using packets with multicast IP address 224.0.0.18 and IP protocol number 112 [1] for IPv4, or ff02::12 ...
The Cisco multicast router AUTO-RP-ANNOUNCE address is used by RP mapping agents to listen for candidate announcements. Yes 224.0.1.40 The Cisco multicast router AUTO-RP-DISCOVERY address is the destination address for messages from the RP mapping agent to discover candidates. Yes 224.0.1.41 H.323 Gatekeeper discovery address Yes 224.0.1.129–132
Cisco Discovery Protocol (CDP) is a proprietary data link layer protocol developed by Cisco Systems in 1994 [1] by Keith McCloghrie and Dino Farinacci. It is used to share information about other directly connected Cisco equipment, such as the operating system version and IP address .
The primary router with the highest configured priority will act as a virtual router with a pre-defined gateway IP address and will respond to the ARP or ND request from machines connected to the LAN with a virtual MAC address. If the primary router should fail, the router with the next-highest priority would take over the gateway IP address ...