Ads
related to: wanderer solar charge controller rs232
Search results
Results From The WOW.Com Content Network
By way of example, a 150 volt PV array connected to an MPPT charge controller can be used to charge a 24 or 48 volt battery. Higher array voltage means lower array current, so the savings in wiring costs can more than pay for the controller. [citation needed] Charge controllers may also monitor battery temperature to prevent overheating.
Portable solar chargers are used to charge cell phones and other small electronic devices on the go. Chargers on the market today use various types of solar panels, ranging from thin film panels with efficiencies from 7-15% (amorphous silicon around 7%, CIGS closer to 15%), to the slightly more efficient monocrystalline panels which offer efficiencies up to 18%.
MAX232 chip in DIP-16 package The die of a MAX232 MAX232 pinout: Red: power, Yellow: charge pump capacitors, Blue: outputs, Green: inputs, Pins 9–12: TTL/CMOS I/O voltages. The MAX232 is an integrated circuit by Maxim Integrated Products, now a subsidiary of Analog Devices, that converts signals from a TIA-232 (RS-232) serial port to signals suitable for use in TTL-compatible digital logic ...
Many RS-232 driver chips have inbuilt charge pump circuitry to produce the required voltages from a 3 or 5 volt supply. RS-232 drivers and receivers must be able to withstand indefinite short circuits to the ground or to any voltage level up to ±25 volts. The slew rate, or how fast the signal changes between levels, is also controlled.
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively). Thus, "software flow control" is sometimes called "XON ...
FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.