Search results
Results From The WOW.Com Content Network
A cable tie (also known as a hose tie, panduit [1], tie wrap, wire tie, zap-straps, or zip tie) is a type of fastener for holding items together, primarily electrical cables and wires. Because of their low cost, ease of use, and binding strength, cable ties are ubiquitous, finding use in a wide range of other applications.
The Resin Identification Code (RIC) is a technical standard with a set of symbols appearing on plastic products that identify the plastic resin out of which the product is made. [1] It was developed in 1988 by the Society of the Plastics Industry (now the Plastics Industry Association ) in the United States, but since 2008 it has been ...
A suffix letter or number may be used with the device number; for example, suffix N is used if the device is connected to a Neutral wire (example: 59N in a relay is used for protection against Neutral Displacement); and suffixes X, Y, Z are used for auxiliary devices.
Mechanical wire wrap tool Electrical wire wrap tool; pneumatic (air-powered) tools are also available. A "wire wrap tool" has two holes. The wire and 1 ⁄ 4 in (6.4 mm) of insulated wire are placed in a hole near the edge of the tool. The hole in the center of the tool is placed over the post. The tool is rapidly twisted.
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
The Telecommunications Industry Association's TIA-598-C Optical Fiber Cable Color Coding is an American National Standard that provides all necessary information for color-coding optical fiber cables in a uniform manner.
This helps ensure that the gun does not discharge in an unsafe manner, causing the nail to become an unrestrained projectile. Due to their potential for causing personal injury, OSHA regulations in the US require certification specific to the tool being used before any person is permitted to rent or use powder-actuated equipment. [ 6 ]
Mullard initially handled semiconductor naming by using the "O" heater code (shifting "Cold Cathode" to a code of "Z"). The second letter broadly indicated the type of device, roughly following the tube designation, without indicating the semiconductor material: A low-power semiconductor diode, e.g. OA7