Ad
related to: 1968 mustang cobra engine specs identification
Search results
Results From The WOW.Com Content Network
In 1968 Carroll Shelby created a custom Mustang using a California Special model and an experimental Ford 428 FE (known as a CJX, precursor to the 428 Cobra Jet). This "Green Hornet" [ 55 ] [ better source needed ] had a custom independent rear suspension, four-wheel disc brakes and a Conelec electronically controlled port fuel injection system.
Although 1969 continued with many of the same basic V8 engines available on 1968 models, notably a revised 302 cu in (4.9 L) small block engine with 220 hp (164 kW; 223 PS), the 390 cu in (6.4 L) FE with 320 hp (239 kW; 324 PS) and the recently launched 428 cu in (7.0 L) Cobra Jet engine (with or without Ram-Air) with an advertised 335 hp (250 ...
The smallest-displacement engine of the 385 engine family, the 370 was introduced after the 429 and 460, replacing the 361 cu in (5.9 L) 360 Truck (FT) V8 in 1977. Sharing its 3.59-inch stroke with the 429, the 370 was designed with a downsized 4.05-inch bore (shared with its predecessor and the 390 V8).
The Shelby Mustang is a high-performance variant of the Ford Mustang built by Shelby American from 1965 to 1967 and by the Ford Motor Company from 1968 to 1970. In 2005, Ford revived the Shelby nameplate for a high-performance model of the fifth-generation Ford Mustang .
The MAF system continued, with minor revisions, until the retirement of the engine in 2001. Ford offered a performance head that was a stock part on 1993–1995 Mustang Cobra models and pre-1997 ½ Ford Explorers and Mercury Mountaineers equipped with the 5.0 L engine called the GT-40 head (casting ID F3ZE-AA). In mid-1997, the Explorer and ...
The Ford Mustang Mach 1 is a combination performance and appearance package offered as an option for the Ford Mustang in August 1968 for the 1969 model year.. Over the following years, the package was available with various engines that became more modest as emissions controls, unleaded gas, fleet mileage quotas, and higher gasoline prices undercut the "horsepower wars" that were the origin of ...
Later models came with hydraulic clutches. These were commonly found in Pintos, some Mustang II/Capris, and Rangers but do not match the V6 Bell housings. Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines.
Introduced on April 1, 1968, the 428 cu in (7.0 L)-4V CJ (Cobra-Jet) FE engine became available as an engine option, but due to its mid-year introduction these engines are very rare. The 428-4V Cobra-Jet was the most potent engine available for 1968, and is general believed to be under-rated at 335 hp (250 kW). [5]