When.com Web Search

  1. Ads

    related to: 1/2 drip line tubing

Search results

  1. Results From The WOW.Com Content Network
  2. Microtubing - Wikipedia

    en.wikipedia.org/wiki/Microtubing

    Microtubing or spaghetti tubing is a very fine plastic tubing used in drip irrigation, typically in gardens and greenhouses, with a small inside diameter which may be 0.05" or smaller. [1] It was introduced in the 1950s in the United States, in Watertown, New York.

  3. Drip irrigation - Wikipedia

    en.wikipedia.org/wiki/Drip_irrigation

    Drip tape is a type of thin-walled dripper line used in drip irrigation. The first drip tape was known as "Dew Hose". [21] Drip tape duct tape is made of polyethylene and sold flat on reels. The wall thickness typically ranges from 0.1 to 0.6 mm (4 to 25 mils). Thicker-walled tapes are commonly used for permanent subsurface drip irrigation, and ...

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

  5. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

  6. Tube (fluid conveyance) - Wikipedia

    en.wikipedia.org/wiki/Tube_(fluid_conveyance)

    Both pipe and tube imply a level of rigidity and permanence, whereas a hose is usually portable and flexible. A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch ...

  7. Subsurface textile irrigation - Wikipedia

    en.wikipedia.org/wiki/Subsurface_textile_irrigation

    The effect of these two layers is dramatic as it maximizes the spread of water through the geotextile (up to 10,000 times faster than a clay loam soil as tested by Charles Sturt University [2]). When comparing SSTI with surface drip, using the same amount of water, SSTI can cover 2.5 times the volume of soil and takes six times longer to dry ...