Ads
related to: distance conversion nautical mile to yards
Search results
Results From The WOW.Com Content Network
A nautical mile is a unit of length used in air, marine, and space navigation, and for the definition of territorial waters. [2] [3] [4] Historically, it was defined as the meridian arc length corresponding to one minute ( 1 / 60 of a degree) of latitude at the equator, so that Earth's polar circumference is very near to 21,600 nautical miles (that is 60 minutes × 360 degrees).
In radar -related subjects and in JTIDS, a data mile is a unit of distance equal to 6000 feet (1.8288 kilometres or 0.987 nautical miles). An international mile is exactly 0.88 of a data mile. The speed of light is 983571056 ft/s, or about one foot per nanosecond. If it were exactly one foot per nanosecond, and a target was one data mile away ...
Legua nautica (nautical league): Between 1400 and 1600 the Spanish nautical league was equal to four Roman miles of 4,842 feet, making it 19,368 feet (5,903 metres or 3.1876 modern nautical miles). However, the accepted number of Spanish nautical leagues to a degree varied between 14 1/6 to 16 2/3, so in actual practice the length of a Spanish ...
Cable length: Length: Fathom: Length: Knot: Speed: League: Length: Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume ...
120 fathoms. 720 ft. Metric (SI) units. 219.5 m. A cable length or length of cable is a nautical unit of measure equal to one tenth of a nautical mile or approximately 100 fathoms. Owing to anachronisms and varying techniques of measurement, a cable length can be anywhere from 169 to 220 metres (185 to 241 yd), depending on the standard used.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
Radar mile or radar nautical mile is an auxiliary constant for converting a (delay) time to the corresponding scale distance on the radar display. [1] Radar timing is usually expressed in microseconds. To relate radar timing to distances traveled by radar energy, you should know that radiated energy from radar set travels at approximately 984 ...
Historically a wide range of units was used for the same type of quantity. In different contexts length was measured in inches, feet, yards, fathoms, rods, chains, furlongs, miles, nautical miles, stadia, leagues, with conversion factors that were not based on power of ten.