Ads
related to: cost to install retaining wall caps pictures to wood posts
Search results
Results From The WOW.Com Content Network
A basement wall is thus one kind of retaining wall; however, the term usually refers to a cantilever retaining wall, which is a freestanding structure without lateral support at its top. [2] These are cantilevered from a footing and rise above the grade on one side to retain a higher level grade on the opposite side.
Intermediate – A post in an exterior wall not at a corner. Chimney – An intermediate post receiving its name from being near a chimney. Interior – A general term for posts not in an exterior wall. Arcade – A post located between an aisle and nave. [10] Aisle – same as arcade post. [11] Corner – Any post at the corner of a building.
Comparison of a ha-ha (top) and a regular wall (bottom). Both walls prevent access, but one does not block the view looking outward. A ha-ha (French: hâ-hâ [a a] ⓘ or saut de loup [so dÉ™ lu] ⓘ), also known as a sunk fence, blind fence, ditch and fence, deer wall, or foss, is a recessed landscape design element that creates a vertical barrier (particularly on one side) while preserving ...
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
sill-beams (also called ground-sills or sole-pieces, at the bottom of a wall into which posts and studs are fitted using tenons), noggin-pieces (the horizontal timbers forming the tops and bottoms of the frames of infill panels), wall-plates (at the top of timber-framed walls that support the trusses and joists of the roof).
A pile cap is a thick concrete mat that rests on concrete or timber piles that have been driven into soft or unstable ground to provide a suitable stable foundation. It usually forms part of the deep foundation of a building, typically a multi-story building, structure or support base for heavy equipment, or of a bridge.
Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles, sheet piles, secant and tangent walls) to provide additional stability to cantilevered retaining walls. [1]
Return wing walls: used where banks are high and hard or firm. Their top width is 1.5 m and face is vertical and back battered 1 in 4. [ 2 ] Scour can be a problem for wing walls and abutments both, as the water in the stream erodes the supporting soil.