Search results
Results From The WOW.Com Content Network
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
Sodium chloride / ˌ s oʊ d i ə m ˈ k l ɔːr aɪ d /, [8] commonly known as edible salt, is an ionic compound with the chemical formula NaCl, representing a 1:1 ratio of sodium and chlorine ions. It is transparent or translucent, brittle, hygroscopic , and occurs as the mineral halite .
In thermodynamics, the Volume Correction Factor (VCF), also known as Correction for the effect of Temperature on Liquid (CTL), is a standardized computed factor used to correct for the thermal expansion of fluids, primarily, liquid hydrocarbons at various temperatures and densities. [1]
11.6 g of NaCl is dissolved in 100 g of water. The final mass concentration ρ(NaCl) is ρ(NaCl) = 11.6 g / 11.6 g + 100 g = 0.104 g/g = 10.4 %. The volume of such a solution is 104.3mL (volume is directly observable); its density is calculated to be 1.07 (111.6g/104.3mL) The molar concentration of NaCl in the solution is therefore
In chemistry, the mass concentration ρ i (or γ i) is defined as the mass of a constituent m i divided by the volume of the mixture V. [1]= For a pure chemical the mass concentration equals its density (mass divided by volume); thus the mass concentration of a component in a mixture can be called the density of a component in a mixture.
This improper name persists, especially in elementary textbooks. In biology, the unit "%" is sometimes (incorrectly) used to denote mass concentration, also called mass/volume percentage. A solution with 1 g of solute dissolved in a final volume of 100 mL of solution would be labeled as "1%" or "1% m/v" (mass/volume). This is incorrect because ...
For liquid solutions, the osmotic coefficient is often used to calculate the salt activity coefficient from the solvent activity, or vice versa. For example, freezing point depression measurements, or measurements of deviations from ideality for other colligative properties, allows calculation of the salt activity coefficient through the osmotic coefficient.
Illustration of uniform compression. The bulk modulus (or or ) of a substance is a measure of the resistance of a substance to bulk compression.It is defined as the ratio of the infinitesimal pressure increase to the resulting relative decrease of the volume.