Ad
related to: what are lath screws used for in painting exterior doors ideas youtube
Search results
Results From The WOW.Com Content Network
Sawn lath became popular after the introduction of the circular saw in the 19th century. Roof laths span across between the rafters and support the wood shingles. A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis ...
At the beginning of the 21st century, this "traditional" method of wire mesh lath and three coats of exterior plaster was still widely used. In some parts of the United States with a warmer climate (like California , Nevada , Arizona , New Mexico and Florida ), stucco is the predominant exterior for both residential and commercial construction.
Battens are also used in metal roofing to secure the sheets called a batten-seam roof and are covered with a batten roll joint. [2] Some roofs may use a grid of battens in both directions, known as a counter-batten system, which improves ventilation. Roofing battens are most commonly made of wood or metal, but can be made of other materials.
Lath seen from the back with white plaster coat oozing through. Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster.
Hand split lath starts with a log of straight grained wood of the required length. The log is split into quarters and then smaller and smaller bolts with wedges and a sledge. When small enough, a froe and mallet were used to split away narrow strips of lath. Farm animals provided hair and manure for the float coat of plaster.
When used to install casing around windows or doors, they allow the wood to be pried off later with minimal damage when repairs are needed, and without the need to dent the face of the casing in order to grab and extract the nail. Once the casing has been removed, the nails can be extracted from the inner frame with any of the usual nail pullers
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
No longer used just as a coating for a substantial material like masonry or log, stucco could now be applied over wood or metal lath attached to a light wood frame. With this increased strength, it ceased to be just a veneer and became a more integral part of the building structure.