Search results
Results From The WOW.Com Content Network
OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...
The optical power budget (also fiber-optic link budget and loss budget) in a fiber-optic communication link is the allocation of available optical power (launched into a given fiber by a given source) among various loss-producing mechanisms such as launch coupling loss, fiber attenuation, splice losses, and connector losses, in order to ensure that adequate signal strength (optical power) is ...
Optical fiber is an intrinsic part of the light-transmitting concrete building product LiTraCon. Optical fiber can also be used in structural health monitoring. This type of sensor can detect stresses that may have a lasting impact on structures. It is based on the principle of measuring analog attenuation.
An optical time-domain reflectometer (OTDR) is an optoelectronic instrument used to characterize an optical fiber. It is the optical equivalent of an electronic time domain reflectometer which measures the impedance of the cable or transmission line under test. An OTDR injects a series of optical pulses into the fiber under test and extracts ...
The optical power margin is usually expressed in decibels (dB). At least several dB of optical power margin should be included in the optical power budget . The amount of optical power launched into a given fiber by a given transmitter depends on the nature of its active optical source ( LED or laser diode ) and the type of fiber, including ...
The S-G-S mode scrambler is actually an assembly, a fusion-spliced concatenation of a step-index profile, a graded-index profile and another step-index profile fiber. [2] Typically, each segment is approximately 1 meter long, and may use segments of unconventional size to produce the distribution required according to core size of fiber to be ...
An optical power meter (OPM) is a device used to measure the power in an optical signal. The term usually refers to a device for testing average power in fiber optic systems. Other general purpose light power measuring devices are usually called radiometers , photometers , laser power meters (can be photodiode sensors or thermopile laser ...
The velocity factor (VF), [1] also called wave propagation (relative) speed or (relative) velocity of propagation (VoP or ), [2] of a transmission medium is the ratio of the speed at which a wavefront (of an electromagnetic signal, a radio signal, a light pulse in an optical fibre or a change of the electrical voltage on a copper wire) passes through the medium, to the speed of light in vacuum.