Search results
Results From The WOW.Com Content Network
Also show PID and to which program each socket belongs, e adds extra info like the user. Run as root to see all PIDs. netstat -s: Shows network statistics. netstat -r: Shows kernel routing information. This is the same output as route -e. netstat -i: Displays a table of all network interfaces. Add -e to get output similar to ifconfig. netstat -ct
-q: Suppresses all output-v: Verbose; COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
A routing table is a data file in RAM that is used to store route information about directly connected and remote networks. Nodes can also share the contents of their routing table with other nodes. The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet.
IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing and queued to the appropriate outgoing interface according to their destination address and a set of rules and performance metrics.
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...
The letter "S" indicates that the route is a static route that has, for all intents and purposes, been added manually to the router process by the administrator and installed into the routing table. Router#enable Router#configure terminal Router(config)#ip route 1.1.1.0 255.255.255.0 fastEthernet 0/0 Router(config)#do show ip route
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.