When.com Web Search

  1. Ads

    related to: ignition time in cylinder engine system tester

Search results

  1. Results From The WOW.Com Content Network
  2. Ignition timing - Wikipedia

    en.wikipedia.org/wiki/Ignition_timing

    Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.

  3. Contact breaker - Wikipedia

    en.wikipedia.org/wiki/Contact_breaker

    The switch is automatically operated by a cam driven by the engine. The timing of operation of the switch is set so that a spark is produced at the right time to ignite the compressed air/fuel mixture in the cylinder of the engine. A mechanism may be provided to slightly adjust timing to allow for varying load on the engine.

  4. Ignition system - Wikipedia

    en.wikipedia.org/wiki/Ignition_system

    A variation coil-on-plug ignition has each coil handle two plugs, on cylinders which are 360 degrees out of phase (and therefore reach top dead center (TDC) at the same time); in the four-cycle engine this means that one plug will be sparking during the end of the exhaust stroke while the other fires at the usual time, a so-called "wasted spark ...

  5. Timing light - Wikipedia

    en.wikipedia.org/wiki/Timing_light

    On most automotive engines, the timing is set based on the #1 cylinder. [1] In few cases an engine is timed off another cylinder, such as the International Harvester V8 engines, which use #8, and the Isuzu 4Z series four-cylinder, which is timed off the #4 cylinder, or the 3 cylinder Saab two-stroke engine which is timed on the middle (#2 ...

  6. Timing mark - Wikipedia

    en.wikipedia.org/wiki/Timing_mark

    A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.

  7. Firing order - Wikipedia

    en.wikipedia.org/wiki/Firing_order

    For this inline-4 engine, 1-3-4-2 could be a valid firing order.. The firing order of an internal combustion engine is the sequence of ignition for the cylinders.. In a spark ignition (e.g. gasoline/petrol) engine, the firing order corresponds to the order in which the spark plugs are operated.