Search results
Results From The WOW.Com Content Network
A Dimroth condenser, also known as a spiral condenser, named after Otto Dimroth, is somewhat similar to the coil condenser; it has an internal double spiral through which coolant flows such that the coolant inlet and outlet are both at the top. [19] [20] The vapors travel through the jacket from bottom to top. Dimroth condensers are more ...
Liebig condenser. The Liebig condenser (/ ˈ l iː b ɪ ɡ /, LEE-big) [1] or straight condenser is a piece of laboratory equipment, specifically a condenser consisting of a straight glass tube surrounded by a water jacket. In typical laboratory operation, such as distillation, the condenser is clamped to a retort stand in vertical
It is used in combination with a reflux condenser and a distillation flask for the separation of water from liquids. This may be a continuous removal of the water that is produced during a chemical reaction performed at reflux temperature, such as in esterification reactions. The original setup by Julius Marcusson (invented in 1905) was refined ...
The condenser microphone, invented at Western Electric in 1916 by E. C. Wente, [22] is also called a capacitor microphone or electrostatic microphone—capacitors were historically called condensers. The diaphragm acts as one plate of a capacitor, and audio vibrations produce changes in the distance between the plates.
Short-path distillation is a distillation technique that involves the distillate traveling a short distance, often only a few centimeters, and is normally done at reduced pressure. [ 1 ] [ 2 ] Short-path distillation systems often have a variety of names depending on the manufacturer of the system and what compounds are being distilled within them.
A microphone’s sensitivity varies with frequency (as well as with other factors such as environmental conditions) and is therefore normally recorded as several sensitivity values, each for a specific frequency band (see frequency spectrum). A microphone’s sensitivity can also depend on the nature of the sound field it is exposed to.
Flat-bottomed flask: A flask with similar uses as the round-bottom flask, but with a flat bottom that allows it to stand on a level surface.; Florence flask: A flask similar to the flat-bottomed flask that has round bodies and either a round bottom or a flat bottom so that one can stand the flask on a level surface.
MVR evaporators with 10 tons or more evaporating capacity are common. The compression ratio in a MVR unit does not usually exceed 1.8. At a compression ratio of 1.8, if the evaporation is performed at atmospheric pressure (0.101 MPa), the condensation pressure after compression will be 0.101 x 1.8 = 0.1818 [MPa].