Search results
Results From The WOW.Com Content Network
For example, in a recipe that calls for 10 pounds of flour and 5 pounds of water, the corresponding baker's percentages are 100% for the flour and 50% for the water. Because these percentages are stated with respect to the weight of flour rather than with respect to the weight of all ingredients, the sum of these percentages always exceeds 100%.
Tumlirz-Tammann-Tait equation of state based on fits to experimental data on pure water. A related equation of state that can be used to model liquids is the Tumlirz equation (sometimes called the Tammann equation and originally proposed by Tumlirz in 1909 and Tammann in 1911 for pure water). [4] [10] This relation has the form
For example, in the brewing industry, the Plato table lists sucrose concentration by weight against true SG, and was originally (20 °C/4 °C) [7] i.e. based on measurements of the density of sucrose solutions made at laboratory temperature (20 °C) but referenced to the density of water at 4 °C which is very close to the temperature at which ...
The couscous that is sold in most Western grocery stores is usually pre-steamed and dried. It is typically prepared by adding 1.5 measures of boiling water or stock to each measure of couscous and then leaving it covered tightly for about five minutes.
The volume of such a mixture is slightly less than the sum of the volumes of the components. Thus, by the above definition, the term "40% alcohol by volume" refers to a mixture of 40 volume units of ethanol with enough water to make a final volume of 100 units, rather than a mixture of 40 units of ethanol with 60 units of water.
Density of pure water at 60 °F = / or / [8] Note: There is no universal agreement on the exact density of pure water at various temperatures since each industry will often use a different standard. For example the, USGS says it is 0.99907 g/cm 3 . [ 9 ]
More accurate measurements become important in the large volumes used in commercial food production. Also, a home cook can use greater precision at times. Water at 4.0 °C (39.2 °F) may be volumetrically measured then weighed to determine an unknown measuring-utensil volume [13] without the need for a water-density adjustment. [14]
Example 1: If a block of solid stone weighs 3 kilograms on dry land and 2 kilogram when immersed in a tub of water, then it has displaced 1 kilogram of water. Since 1 liter of water weighs 1 kilogram (at 4 °C), it follows that the volume of the block is 1 liter and the density (mass/volume) of the stone is 3 kilograms/liter.