Ads
related to: dlc connector how many pins go on 5 ton log splitter
Search results
Results From The WOW.Com Content Network
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
A log splitter is a piece of machinery or equipment used for splitting firewood from softwood or hardwood logs that have been pre-cut into sections (rounds), usually by chainsaw or on a saw bench. Many log splitters consist of a hydraulic pump or electric motor which then powers a hydraulic or electrical rod and piston assembly.
Here, the log is simply forced into a wedge that splits the round into anywhere between two and sixteen pieces, depending on the size of the logs and the intended market. Multitek North America patented a 16 way, box head splitter which can handle up to 18 inch diameter logs. [2]
One such in somewhat common use was the VHDCI (Very High Density Cable Interconnect) connector, also known as an "AMP HPCN68M", and sometimes as "SCSI-5". There are 68 pins on the connector in two rows; the pins are 0.8 mm apart. This connector is reputed to suffer fewer bent pins than the 68-pin SCSI-2 connector despite its minuscule pins.
MC4 connectors are successors of the MC3 Connectors, which were developed by Multi-Contact in 1996. MC3 is the abbreviation of Multi-Contact and its size 3mm PV connector with 3 mm contact pin. MC3 had certification ratings of (1000VIEC/600V UL) and 30A (10AWG PV Cable). The MC3 connectors were discontinued in 2016.
The de facto standard 5.25 inch FDD interface is based upon the Shugart Associates SA400 [6] FDD. [5]: 169 The signal interface uses a 34-pin PCB edge connector which mates to a flat ribbon cable connector. DC power is provided on a separate connector. [6] The 34-pin connector is similar in pinout to the standard 50-pin connector for 8 inch FDDs.
A connector plug with all 60 pins (such as a Molex 88766-7610 DVI-I splitter) does not fit into a properly keyed DMS-59 socket. A Dual-DVI breakout cable can be used in connection with two passive DVI-to-HDMI adapters to feed modern displays with HDMI inputs, while using a DMS-59 graphics card, since the DVI signals are electrically identical ...
The UEXT connector consists of 10 pins, in a two row by five male pin configuration, with a plastic keyed-shrouded or box header (specifically BH10S). All pins have a spacing of 0.1 inch (2.54 mm). [1] [2] The socket is mated with a 2×5 (10-pin) IDC female connector, and typically connected to a ribbon cable.