Ads
related to: what is a cable length of service chart for one person table and four
Search results
Results From The WOW.Com Content Network
Data rate versus line length chart, from RS-422 Annex A.1. Several key advantages offered by this standard include the differential receiver, a differential driver and data rates as high as 10 megabits per second at 12 meters (40 ft). Since the signal quality degrades with cable length, the maximum data rate decreases as cable length increases.
A cable in this usage cable is a thick rope or by transference a chain cable. [1] The OED gives quotations from c. 1400 onwards. A cable's length (often "cable length" or just "cable") is simply the standard length in which cables came, which by 1555 had settled to around 100 fathoms (600 ft; 180 m) or 1 ⁄ 10 nautical mile (0.19 km; 0.12 mi). [1]
[4]: p.12–14 If the electrical length is much less than one, that is the physical length of a conductor is much shorter than the wavelength, say less than one tenth of the wavelength (< /) it is called electrically short. In this case the voltage and current are approximately constant along the conductor, so it acts as a simple connector ...
Cable length: Length: Fathom: Length: Knot: Speed: League: Length: Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume ...
(The resistors are in parallel, so a properly terminated bus should have a total resistance of 60Ω). The maximum distance for any device from the bus is six metres. The maximum backbone cable length is 250 meters (820 feet) with Mini cable backbone or 100 meters (328 feet) with Micro cable backbone [3] Typical NMEA 2000 Network Installation
A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs). Crossover cables are sometimes still used ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
The antenna is often mounted outdoors on the roof or a tower. A coaxial or twin-lead cable is run from the antenna to the location where the television is located. One common type of cable is designated RG-6 Tri-shield or quad-shield cable. The cable is terminated on a television outlets, typically an F connector mounted on a face plate. If ...