Ads
related to: header pin sizes
Search results
Results From The WOW.Com Content Network
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector.A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1]
There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A. Because the pins have a large contact surface area and fit tightly, these connectors are typically used for power.
JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [2] [3] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, 3D printers, and radio controlled servos. [4]
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
Plastic leaded chip carrier (PLCC): square, J-lead, pin spacing 1.27 mm; Quad flat package : various sizes, with pins on all four sides; Low-profile quad flat-package : 1.4 mm high, varying sized and pins on all four sides; Plastic quad flat-pack , a square with pins on all four sides, 44 or more pins
Five-pin male 180° DIN connector from a 1988 Schneider MF2 keyboard by Cherry. The DIN connector is an electrical signal connector that was standardized by the Deutsches Institut für Normung (DIN), the German Institute for Standards, in the mid 1950s, initially with 3 pins for mono, but when stereo connections and gear appeared in late 1950s (1959 or so), versions with 5 pins or more were ...