Ad
related to: pin header footprint
Search results
Results From The WOW.Com Content Network
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.
Populated (rear) and unpopulated (front) TSOP land patterns on a printed circuit board. A row of through-holes acting as the footprint for a pin header.. A footprint or land pattern is the arrangement of pads (in surface-mount technology) [1] or through-holes (in through-hole technology) used to physically attach and electrically connect a component to a printed circuit board.
JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [2] [3] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, 3D printers, and radio controlled servos. [4]
Pins and sockets can be arranged in any combination in a single housing, and each housing can be either male or female. There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A.
Plastic leaded chip carrier (PLCC): square, J-lead, pin spacing 1.27 mm; Quad flat package : various sizes, with pins on all four sides; Low-profile quad flat-package : 1.4 mm high, varying sized and pins on all four sides; Plastic quad flat-pack , a square with pins on all four sides, 44 or more pins
BTB connectors are divided up into four mounting types: Through-hole technology; Surface-mount technology; Plug-in technology [1]; Solderless stacking mezzanine technology [2]; BTB connectors are selected by considering the mounting method, pin pitch, number of the rows (aka number of the ways), pin length, stacker height etc.
Simple shield-compatible board, with onboard discrete transistor H-bridges and screw terminals to drive two small DC motors from pins 4–7. [137] Has headers for three servos on pins 9–11. Also sold with the Faraduino buggy kit [138] and Faraconnect shield [139] as a simple school-level teaching robot. Motoruino [140] ATmega328 Yes
For example, the DE-15, usually found in VGA cables, has 15 pins in three rows, all surrounded by an E size shell. The pins are spaced at 0.090 inches (2.3 mm) horizontally and 0.078 inches (2.0 mm) vertically, [7] in what is called high density. The other connectors with the same pin spacing are the DA-26, DB-44, DC-62, DD-78 and DF-104.