Search results
Results From The WOW.Com Content Network
The VTi Engine (Variable Valve Lift and Timing injection) is a variable valve timing (VVT) system for Prince engine created jointly by both PSA (Peugeot, Citroën, DS Automobiles) and Mini from the BMW Group.
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
The first-stage of the scuba regulator may be connected to the cylinder valve by one of two standard types of fittings. The CGA 850 connector, also known as an international connector, which uses a yoke clamp, or a DIN screw fitting to connect it to the valve of the diving cylinder. There are also European standards for scuba regulator ...
A back-pressure regulator, back-pressure valve, pressure sustaining valve or pressure sustaining regulator is a control valve that maintains the set pressure at its inlet side by opening to allow flow when the inlet pressure exceeds the set value.
Cylinder head of Honda K20Z3.This engine uses continuously variable timing for the inlet valves. Variable valve timing (VVT) is the process of altering the timing of a valve lift event in an internal combustion engine, and is often used to improve performance, fuel economy or emissions.
The normally closed valves will not permit flow from the inlet port of the valve to the outlet port, normally the flow will be permitted only by changing the position of the valve. In general, valves are designated as 2/2 DCV, 3/2 DCV, 5/2 DCV, 5/3 DCV etc., in which the first number indicates number of ports and second number indicates number ...
The 2.5-litre 6G73 is a 24-valve SOHC design with two valves running off a single cam lobe on the exhaust valves using a forked rocker arm and each intake valve actuated with two cam lobes, with a smaller bore than the 3.0L version of the same block. Bore and stroke are 83.5 mm × 76 mm (3.29 in × 2.99 in); it is a 60-degree V6 and weighs ...
In reduced bore (sometimes reduced port) ball valves, flow through the valve is one pipe size smaller than the valve's pipe size resulting in the flow area being smaller than the pipe. As the flow discharge remains constant and is equal to the area of flow (A) times velocity (V), A 1 V 1 = A 2 V 2 {\displaystyle A_{1}V_{1}=A_{2}V_{2}} the ...